Aug 24
2019

Learning The “Secrets” of

Guidelines on how to go about Replacing your Fence in Person

You may notice that your fence is sagging or has gotten so dry that it is exposing your compound. The fence can break down completely without you noticing, if you are keen enough. The details of the fence can be the reason for the deterioration of the fence. Here the factors that you should consider when replacing your fence.

You should be familiar with the local laws relating to zoning. The authorities will have to approve construction of certain structures. It doesn’t matter whether you will be using the same materials and putting them on the same spots as they previously were. You may end up getting fined for doing a construction without the permits and legal documents. The new fence has to constructed in accordance to the set standards. You may as well get fined or asked to put the fence down if it doesn’t comply with the set guidelines. Even if you are intending to reestablish the fence on the same position as the old one, you should be able to see your utility provider. This is important because you don’t want to interfere with water or electricity lines passing underground.

You should also consider the available materials and the required materials for the construction of the new fence. You should bear in mind the number of years you want your new fence to last then identify the materials you are supposed to buy. Your budget also needs to be considered before you go out to buy the building materials. You need to buy wood of higher grade so that the fence can last a lot longer. However, this type of wood comes at a higher budget, and if you have enough money, you can entirely upgrade the fence by using aluminum vinyl in place of wood. In order for you to dig deeper for the posts, you need to eliminate all the materials belonging to the old fence from the site. A strong fence has to be constructed from the ground to the top with strong foundation and materials.

Mapping out the layout of your new fence should be done so that you can know how many posts you will need. The position of the posts and the corner points must be identified as well. You can use strings and batters to do the markings. Digging of holes should then follow using a digging bar and shovel. Power augers can be used to dig the holes if the compound is huge because you may end up spending a lot of energy and time to accomplish the digging. You should ensure that the holes are deep enough according to the codes, and then set the posts in those holes.

Leave a Reply

Your email address will not be published. Required fields are marked *